How To
The belt reel contains two parts – the base, which has with two sides, and the lid, with no sides.
The base has two small holes on one side to allow a ribbon to be fed through so you can hang your belt reel with its corresponding dress.
To load a belt on the belt reel, the wound belt is inserted around the inner ring of the base.
Follow the steps below:
Base
Lid
To open the reel, hold the base and rotate the lid anticlockwise, then lift to separate the lid from base.
Step 1
Holding the end of the belt, loop the belt on itself so the tip of the belt end meets between the third and fourth eyelet.
Step 2
Using your thumb to hold the end of the belt in this position, continue winding the belt until the full length of the belt is wound around itself and the buckle is on the outside of the wound belt.
Step 3
Insert the wound belt over the inner ring of the base of the belt reel. The buckle can be left in the opening between the two enclosed sides.
Step 4
Insert the lid and lock into the base, turning the lid clockwise.
Step 5
To remove the belt, simply pull the buckle to unwind the belt from the reel.